Monitor Audio ASW100 User Manual download pdf (Page 99)

Configuring the AM700

AM700 Audio Measurement Set User Manual

3-13

System Setup Menu

The System Setup menu is used to set the system clock, the serial and GPIB

communication parameters, the hard copy output format, run the AM700 calibration

routine, and set the input, output, and dBFS conversion factors.

Refer to Setting the AM700 Clock on page 1-10 for a detailed procedure for setting

the system clock. Select the parameter to change, then set the new number. When all

the numbers have been set correctly, press Accept Changes to set the clock to the

new time.

The control screen display for setting the Copy parameters is reached either through

the Configure System Setup menu or directly by pressing and holding the Copy

front-panel button to bring up the same menu. Press and hold the Copy button to

display the Copy Configuration screen (see Figure 3-10 on page 3-14).

NOTE. Pressing and holding the Copy button immediately brings up the Configure

menu with the System Setup choices for Copy displayed. This is the same screen that

is displayed by pressing the Configure button, then System Setup.

In this screen you can set the following copy functions:

H Copy output format

H Copy destination

H File name when File is the selected copy destination

After setting copy options, touch the Accept Changes soft key to save your

selections, exit the Copy Configuration screen, and return to the measurement

display.

Setting the

System

Clock

System Copy

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 317 318

No comments

Monitor Audio ASW100 User Manual Page 99