Monitor Audio ASW100 User Manual download pdf (Page 129)

Audio Generator

AM700 Audio Measurement Set User Manual

4-17

If necessary, select the desired waveform from the Waveform pop-up selection. Set

the amplitude or frequency by turning the front panel Amplitude or Frequency knob,

as appropriate, or activate the field editor by touching it. With the field editor active,

you can rotate the large control knob to change the value in the field. You can also

enter the desired value in the active window from the keypad. Press Enter or touch

the field editor to accept the changes.

Waveform Control

Touch the soft key to display the Waveform Control screen (see Figure 4-6). Menus

in this screen apply only to the parameters of the selected generator (the one that has

the diamond highlighted at the top of the display). The generators being edited are

indicated at the top of the display. In Figure 4-6 the generators for which choices

can be made are the Analog High Resolution Generator and the AES Digital

Generator. If Analog A is generating a sine wave, then the available waveform

control parameters are frequency and amplitude. However, if you touch the Digital

SF 1 soft key and the digital generator is generating another type of waveform the

parameters accessible in the Waveform Control screen may change, depending on

the waveform being generated.

NOTE. Sine wave only can be used for generating a sweep signal. If a sweep is

wanted from a particular generator, it must be set to generate a sine wave signal

either in the Waveform Control menu or in the Generator Control panel.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 317 318

No comments

Monitor Audio ASW100 User Manual Page 129