Monitor Audio Vector Service Manual download pdf (Page 134)

Remove and Replace

6-34

WFM90D and WFM91D Service Manual

Remove. To remove the turnlock stud receptacle:

1. Remove the bottom cover. Refer to Bottom Cover on page 6--31.

2. Depress the retaining fingers on the turnlock stud receptacle and push the

receptacle through the bottom cover. See Figure 6--16.

Remove. To replace the turnlock stud receptacle:

1. Push the turnlock stud receptacle through the bottom cover. Be sure the

retaining fingers snap into position. See Figure 6--16.

2. Install the bottom cover. Refer to Bottom Cover on page 6--31.

Remove. To remove the electrical shield:

1. Remove the bottom cover. Refer to Bottom Cover on page 6--31.

2. Pry up the electrical shield on the inside of the bottom cover around the

edges and peel it off of the bottom cover.

3. If necessary, clean the surface of the bottom cover to remove any remaining

glue residue.

Replace. To replace the electrical shield:

1. Peel the protective covering off the adhesive surface of the electrical shield.

2. Position the electrical shield above the inside of the bottom cover and align

the hole in the shield with the hole in the bottom cover.

3. Press the shield onto the bottom cover and rub the shield to make sure it is

securely in place.

4. Install the bottom cover. Refer to Bottom Cover on page 6--31.

Turnlock Stud Receptacle

Bottom Cover Electrical

Shield

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 179 180

No comments

Monitor Audio Vector Service Manual Page 134