Monitor Audio Vector Service Manual download pdf (Page 128)

Remove and Replace

6-28

WFM90D and WFM91D Service Manual

Remove. To remove the battery cushion pad:

1. Remove the battery cover. Refer to Battery Cover on page 6--25.

2. To remove the cushion pad, pry it up around the edges and pull it off of the

battery cover.

3. If necessary, clean the surface of the cushion pad to remove any remaining

glue residue. See Cleaning on page 6--1.

Replace. To replace the battery cushion pad:

1. Peel off the protective covering of the adhesive surface of the cushion pad.

2. Position the cushion pad in place above the battery cover before you press it

onto the battery cover. Rub your fingers over the pad once it is positioned on

the battery cover to make sure the pad is securely in place.

3. Install the battery cover. Refer to Battery Cover on page 6--25.

Batteries

There are two procedures for replacing the batteries. The first is for the optional

NiMH battery pack and second is for alkaline batteries.

Remove. To remove the NiMH battery pack:

1. Remove the battery cover. Refer to Battery Cover on page 6--25.

2. Grasp the batteries close to the wire leads. Use your thumb to press in on the

top portion of the battery connector tab, and then pull gently upwards. See

Figure 6--13.

Replace.

1. Press the battery connector onto the jumper in the battery compartment. B e

sure the battery connector tab snaps onto the jumper housing to prevent a

loss of battery power.

2. Install the battery cover. Refer to Battery Cover on page 6--25.

Battery Cushion Pad

NiMH Battery Pack

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 179 180

No comments

Monitor Audio Vector Service Manual Page 128