Monitor-audio 100 User Manual download pdf

Installation Guide

100 Series

monitoraudio.co.uk

Painting

NOTE: If you are choosing to paint your 100 Series loudspeaker, we recommend you do this prior to installation by following

these simple steps:

1. Remove the membrane scrim from the inside of the grille (do not fit grille to speaker frame).

2. Place paint mask over the speaker baffle.

3. Paint both the frame and the grille at the same time and with the same batch of paint (if they are to be the same

colour).

4. When they are both dry, remove the paint mask from the baffle, and place the spare membrane scrim (in the packaging)

into the inside of the grille.

5. Your product(s) are now ready to install, including fitting the grille.

Using Pre-Construction Brackets

If the holes have been pre-cut, simply refer to step 4 onwards (below) for full fitting instructions.

If pre-construction brackets have been used prior to the fixing of plaster board/ sheet rock and the holes have not been cut,

locate the pre-construction brackets and cut around the inside edge of the bracket. Locate the speaker cable, connect to the

sprung terminals and fit the speaker. Refer to the fitting instructions below (step 4 onwards).

To fine-tune the speakers please refer to the high frequency control and boundary compensation details below

Using the Fixing Template

1. Use template to locate position of cut out. The adhesive backing allows for repositioning a number of times.

2. Draw around diameter of the template.

3. Remove template and cut hole.

4. Locate speaker cable and connect by pushing the terminals in and releasing to clamp the cables.

5. Fit product into prepared hole and tighten fixing clamps. These will move outwards automatically upon tightening!

DO NOT OVER TIGHTEN! Once contact is made 2-3 turns are all that is required.

6. To fine-tune the speakers please refer to the high frequency control details below.

High Frequency control

The factory H.F setting provides a flat or 0dB level, which will suit the majority of typical installations.

Setting the switch in the +3dB position will add brightness and additional clarity to the system. This may be effective in a

room with a large amount of soft furnishings.

Setting the switch in the -3dB position will reduce the brightness and provide a duller sound. This may be effective in a room

with a few of soft furnishings, or in an installation with a wooden floor.

Installation procedures

Monitor Audio Ltd

Unit 2, 24 Brook Road

Rayleigh, Essex

SS6 7XL

England

Tel: 01268 740580

Fax: 01268 740589

Email: info@monitoraudio.co.uk

monitoraudio.co.uk

Designed in the United Kingdom

1 2

Summary of Contents

Page 1 - Installation procedures

Installation Guide100 Seriesmonitoraudio.co.ukPaintingNOTE: If you are choosing to paint your 100 Series loudspeaker, we recommend you do this prior

Page 2 - Installation guide

100 SeriesThe 100 Series utilises bass drivers featuring the advanced MMP®II cone technology together with Monitor Audio’s trade mark C-CAM® gold dome

Comments to this Manuals

No comments

Monitor-audio 100 User Manual

Browse online or download User Manual for Microphones Monitor-audio 100. Monitor Audio 100 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Microphones Monitor-audio 100